Saving different profiles/settings

General discussion of using Roboclaw motor controllers
Post Reply
Joe
Posts: 34
Joined: Fri Dec 23, 2016 1:00 am
Saving different profiles/settings

Post by Joe »

How can I save different Roboclaw configuration profiles for testing in Ion Motion Software?
User avatar
Basicmicro Support
Posts: 1594
Joined: Thu Feb 26, 2015 9:45 pm
Re: Saving different profiles/settings

Post by Basicmicro Support »

Currently you can not. We are planning on adding the ability but I'm not sure it will be in the next release.
Joe
Posts: 34
Joined: Fri Dec 23, 2016 1:00 am
Re: Saving different profiles/settings

Post by Joe »

Hi, I've been away for a while so I missed some versions of IonStudio. Any news on that?
User avatar
Basicmicro Support
Posts: 1594
Joined: Thu Feb 26, 2015 9:45 pm
Re: Saving different profiles/settings

Post by Basicmicro Support »

The current release doesnt have it yet but the next release will allow you to save/load settings from a file. We added it just this week(after the new release unfortunately).
Joe
Posts: 34
Joined: Fri Dec 23, 2016 1:00 am
Re: Saving different profiles/settings

Post by Joe »

Is it possible now? I can´t find any information in the manual.
User avatar
Basicmicro Support
Posts: 1594
Joined: Thu Feb 26, 2015 9:45 pm
Re: Saving different profiles/settings

Post by Basicmicro Support »

Yes. It is now possible to save/load settings to/from a file in Motion Studio(the new, renamed release).

Post Reply