Re: Fail to update the firmware and connection lost
Posted: Tue Jul 17, 2018 10:50 am
1. make sure you power the board from the main power conntions. USB will NOT power the board properly. USB power is only used to detect the connection and only some parasitic power may bleed through.
2. Power cycle the board.
3. Check Windows Device manager to see fi the Roboclaw shows up under Ports. It will show as a generic Atmel CDC Virtual Comport.
4. Re-start Ion Studio. Press Update Firmware. Do not press Connect to Selected Device before updating. It will just tell you that you need to update the firmware first.
2. Power cycle the board.
3. Check Windows Device manager to see fi the Roboclaw shows up under Ports. It will show as a generic Atmel CDC Virtual Comport.
4. Re-start Ion Studio. Press Update Firmware. Do not press Connect to Selected Device before updating. It will just tell you that you need to update the firmware first.