Roboclaw interface with Jetson Tx2

General discussion of using Roboclaw motor controllers
Post Reply
User avatar
Basicmicro Support
Posts: 1594
Joined: Thu Feb 26, 2015 9:45 pm
Re: Roboclaw interface with Jetson Tx2

Post by Basicmicro Support »

Unlike Linux, Windos requires a signed .inf file/driver to be installed for each CDC Virtual comport device. Linux should install the Roboclaw without need of a driver.

You need an interface from ROS to the Roboclaw(a ROS software node that knows how to talk to the Roboclaw). What are you using?

Post Reply