RC drive stopped after upgrade to 4.1.29. Reset to defaults and reprogram resolved the issue.
Posted: Sun Jan 27, 2019 7:13 am
Basic micro team,
I have a Robocla 2x45. I'm using RC control to drive the motors. After upgrading to 4.1.29 the motor drive stopped working completely. The board was working, it would connect to the studio software. I could control the motors via the controls in the studio software, but external RC input had no affect.
I came looking here for hints and came across a post where RC control changed behavior after 4.1.20 and before 4.1.29. Based on that hint I decided to try a reset to defaults and reprogram. That resolved my issue. I feel it is important that you and your development team understand the issue I encountered. I'm a software tester, I know that development can't fix what they aren't told about.
I have a Robocla 2x45. I'm using RC control to drive the motors. After upgrading to 4.1.29 the motor drive stopped working completely. The board was working, it would connect to the studio software. I could control the motors via the controls in the studio software, but external RC input had no affect.
I came looking here for hints and came across a post where RC control changed behavior after 4.1.20 and before 4.1.29. Based on that hint I decided to try a reset to defaults and reprogram. That resolved my issue. I feel it is important that you and your development team understand the issue I encountered. I'm a software tester, I know that development can't fix what they aren't told about.