Are these the correct digikey parts?

[JorgeP]

Will these Digikey parts be appropriate for the MCP263? http://www.digikey.com/short/qqmhvv The screws, I am guessing, are the appropriate size for mounting the controller to 1/8 to 1/4 inch steel drilled and tapped for 4-40?

Thank you for your time
Jorge

[Basicmicro Support]

Yes, those parts all look correct.

[JorgeP]

Well, it turns out that the 15 pin connector was not the correct part, it should have been the male connector. Can't Ion Motion just make these parts available in the store? Maybe popup as a recommended item when an MCP, or other controller, is added to the cart so we are guaranteed to have the correct items without having to go to digikey or another supplier. You most likely order them for in-house use anyways, testing, etc...

Just wanted to post my error in case anyone uses the list to make a purchase without double checking

[Basicmicro Support]

Hmm. I apologize. I completely missed that.

Some of these parts we plan on adding(eg the DB15 and Molex connectors themselves) however we are still debating whether to have customer wiring harness built or just make the components available.

[JorgeP]

Hmm. I apologize. I completely missed that.

No harm done, I should have taken a closer look before I posted. I did update the list so it should be correct now. I will confirm it today when the parts come in and re-update the list if necessary.