problem whith roboclaw 2*60A
- Basicmicro Support
- Posts: 1594
- Joined: Thu Feb 26, 2015 9:45 pm
Re: problem whith roboclaw 2*60A
1. Make sure you are using the latest firmware(4.1.24). Ion studio will show the correct wiring for bridged mode. Make sure you have your physical wiring exactly as show when you set bridged mode.
2. What control method are you using(RC,Analog, Packet serial?)
3. If you disable bridged mode(and re-wire the motor) does it work correctly on each channel separately?
2. What control method are you using(RC,Analog, Packet serial?)
3. If you disable bridged mode(and re-wire the motor) does it work correctly on each channel separately?