Current limit on roboclaw 2x7A

General discussion of using Roboclaw motor controllers
Post Reply
User avatar
Basicmicro Support
Posts: 1594
Joined: Thu Feb 26, 2015 9:45 pm
Re: Current limit on roboclaw 2x7A

Post by Basicmicro Support »

Please contact support directly(support@basicmicro.com). They will give you a link to the pre-release which has better current limit control.

Note a 1amp current limit is very low and may not be possible. It will depend on the motor being used mostly. What are you driving that you need to limit the current to 1amp?
Top
Post Reply

Return to “General Discussion”