Search found 7 matches
- Fri Nov 06, 2020 2:07 am
- Forum: General Discussion
- Topic: Before i purchase roboclaw 60a solo, will it function like this please?
- Replies: 3
- Views: 5038
Re: Before i purchase roboclaw 60a solo, will it function like this please?
Thanks for the explanation, I'll keep that in mind and will then have it shipped to my parents' address and pick it up later.
- Tue Oct 27, 2020 5:40 am
- Forum: General Discussion
- Topic: Before i purchase roboclaw 60a solo, will it function like this please?
- Replies: 3
- Views: 5038
Re: Before i purchase roboclaw 60a solo, will it function like this please?
Speaking of the Roboclaw 60a, would it be possible to have it shipped to a hotel or an AirBnB address? Because I'll spend a couple months in spring in Greece, visiting some of these Athens house for insurance estimates, and I'll spend 2 to 3 weeks in different countries for the following 2 months af...
- Mon Oct 26, 2020 9:08 am
- Forum: General Discussion
- Topic: Settings resets to default after firmware update
- Replies: 9
- Views: 5703
Re: Settings resets to default after firmware update
That's exactly what I'm doing right now, glad to know I was doing the right thing, I hope it'll help the other members, too.
- Mon Oct 26, 2020 9:07 am
- Forum: General Discussion
- Topic: Configuration
- Replies: 12
- Views: 11369
Re: Configuration
Yes, you'll need to be able to account for terrain differences, unless you're only going to let your rover drive over a perfectly flat surface. It has to be able to detect something unpracticable on its path (a steep grade, an unmovable obstacle, water...) and, possibly, to find a way to deal with i...
- Mon Oct 26, 2020 9:02 am
- Forum: General Discussion
- Topic: About precharge resistor while using secondary PS for LB
- Replies: 4
- Views: 3772
Re: About precharge resistor while using secondary PS for LB
If all switches are off there is no power to the Roboclaw so there shouldnt be any blinking. If you use the bare simplest circuit there is a small amount of power getting to the Roboclaw(1ma with a 1k resistor). This will not usually be enough power to run the Roboclaw but could cause the LEDs to g...
- Mon Oct 26, 2020 4:42 am
- Forum: General Discussion
- Topic: Settings resets to default after firmware update
- Replies: 9
- Views: 5703
Re: Settings resets to default after firmware update
Okay, thanks, then I should be able to do it myself as I upgraded my version from an older one!
- Wed Oct 21, 2020 7:48 am
- Forum: General Discussion
- Topic: Settings resets to default after firmware update
- Replies: 9
- Views: 5703
Re: Settings resets to default after firmware update
Is it possible to restore older versions for as far back in time as you had Motion Studio installed on your computer, or is it only possible under certain conditions?