Search found 2 matches
- Thu Feb 18, 2021 3:11 pm
- Forum: General Discussion
- Topic: Component confirmation
- Replies: 3
- Views: 2791
Re: Component confirmation
Thank you for the fast response yes I may go with a lower ohm resistor to speed things up a little. You did not say anything about the bypass diode so I'm guessing it's ok or not overly important, I wasn't sure about the voltage rating on it I guessed the higher the better. Thank you again
- Wed Feb 17, 2021 6:53 pm
- Forum: General Discussion
- Topic: Component confirmation
- Replies: 3
- Views: 2791
Component confirmation
Hi I would like some confirmation on my pre charge resistor selection on my 2x60A Robclaw running at 24 volts. I know a lot of people ask this question but I would like know for sure before I fry a high end controller. Website says 2x60A Roboclaw is 1080uF changed to farad is 0.00108f for 1 second s...