Search found 29 matches

by Joe
Thu May 30, 2019 3:08 pm
Forum: General Discussion
Topic: Connect to Basicmicro Motion Studio w/o updating fw
Replies: 1
Views: 455

Connect to Basicmicro Motion Studio w/o updating fw

Hello,
I downloaded the recent version of Motion Studio. After connecting my Roboclaw it asks for an fw update.
How can I use the Motion Studio software without updating the firmware? Can't find a 'cancel update' button.
Joe
by Joe
Wed Oct 24, 2018 8:03 am
Forum: General Discussion
Topic: After firmware update RC is not working as expected
Replies: 4
Views: 2012

Auto Tune

Why does auto tune M2 affect the values (PID) of M1?
by Joe
Wed Oct 24, 2018 2:55 am
Forum: General Discussion
Topic: After firmware update RC is not working as expected
Replies: 4
Views: 2012

After firmware update RC is not working as expected

After longer time I decided to update my RC2x30 firmware from 4.1.24 to 4.1.27 due to the possibility of saving different profiles. After update all settings on my RC were gone. :o I tried to configure everything again, but RC is not working as before with 4.1.24 firmware. For example motors running...
by Joe
Sun Oct 07, 2018 12:49 am
Forum: General Discussion
Topic: Saving different profiles/settings
Replies: 5
Views: 3372

Re: Saving different profiles/settings

Is it possible now? I can´t find any information in the manual.
by Joe
Sun Jul 01, 2018 12:01 pm
Forum: General Discussion
Topic: Saving different profiles/settings
Replies: 5
Views: 3372

Re: Saving different profiles/settings

Hi, I've been away for a while so I missed some versions of IonStudio. Any news on that?
by Joe
Tue Mar 27, 2018 11:51 am
Forum: General Discussion
Topic: Limit switches to cut power
Replies: 1
Views: 1496

Limit switches to cut power

For security reasons I want to use two switches additionally to the regular end switches on my linear unit. These additional switches should cut the power off. I'm using a relay module to do that. Should I cut the power of the motors or should I cut the power of roboclaw itself? How does roboclaw re...
by Joe
Tue Mar 20, 2018 3:32 am
Forum: General Discussion
Topic: 5V for arduino
Replies: 3
Views: 2141

Re: 5V for arduino

... and all of the pins provide up to 3A together?
by Joe
Fri Mar 16, 2018 9:59 am
Forum: General Discussion
Topic: 5V for arduino
Replies: 3
Views: 2141

5V for arduino

Hi, if I'm using 2 encoders with roboclaw where should I take the 5V for powering an arduino?
by Joe
Sun Feb 25, 2018 10:48 am
Forum: Velocity and Position Control
Topic: Doing one command after the other
Replies: 9
Views: 4096

Re: Doing one command after the other

Thank you that helped ;-)
by Joe
Wed Feb 21, 2018 2:27 pm
Forum: Velocity and Position Control
Topic: Doing one command after the other
Replies: 9
Views: 4096

Re: Doing one command after the other

Hi this is the relating part of my sketch and the printed buffer. RC does only the first two position commands and the last to the starting position 400. The following two (5500 and 7500) are ignored and no more serial read out. void measure{ uint8_t depth1,depth2; rc.SpeedAccelDeccelPositionM1(addr...