Search found 5 matches
- Fri Sep 25, 2020 12:24 pm
- Forum: General Discussion
- Topic: About precharge resistor while using secondary PS for LB
- Replies: 4
- Views: 3737
Re: About precharge resistor while using secondary PS for LB
Then, it's LED blinking behavior is expected and normal as both switches off ?
Thanks,
Thanks,
- Wed Sep 23, 2020 9:36 am
- Forum: General Discussion
- Topic: About precharge resistor while using secondary PS for LB
- Replies: 4
- Views: 3737
About precharge resistor while using secondary PS for LB
Hi, Considering the below setup given in Roboclaw 2x15A datasheet, as SW1 and SW2 are off the driver LEDs are constantly flashing. Because of the leakage current through R1(1Kohm) the driver tries to start but it cannot do so. Due to this leakage current the battery depletes in the long term. Does a...
- Wed Sep 23, 2020 8:13 am
- Forum: General Discussion
- Topic: Settings resets to default after firmware update
- Replies: 9
- Views: 5641
Re: Settings resets to default after firmware update
However I already formatted my computer so I don't have the previous version of BMS. When I uninstall the last version of BMS then I don't have any BMS.
- Tue Sep 15, 2020 12:50 pm
- Forum: General Discussion
- Topic: Settings resets to default after firmware update
- Replies: 9
- Views: 5641
Settings resets to default after firmware update
Hi, I previously configured some RoboClaw 2x15A Motor Controllers firmware 4.1.33. Now I need to read back the settings by Basicmicro Motion Studio (BMS). When I tried to connect driver it asked to update the firmware to 4.1.34 then I updated. But the drivers settings appeared to be restored to fact...
- Wed May 08, 2019 9:09 am
- Forum: General Discussion
- Topic: Reasons for Fault Conditions
- Replies: 1
- Views: 2185
Reasons for Fault Conditions
Hi, One of my RoboClaw 2x15A V5E gives M2 Driver Fault error but M1 channel works. When I try to increase the PWM of M2 it gives M2 Fault Error. What is the probability of burned FET? Is there any other reason for Driver Fault error. What about A4940 or any other reason. Am I able to fix the problem...