Search found 5 matches
- Fri Mar 29, 2019 2:57 pm
- Forum: General Discussion
- Topic: Control of multiple chained Roboclaws
- Replies: 4
- Views: 3853
Re: Control of multiple chained Roboclaws
Excellent. Just what I was hoping to hear.
- Wed Mar 27, 2019 2:06 pm
- Forum: General Discussion
- Topic: Control of multiple chained Roboclaws
- Replies: 4
- Views: 3853
Control of multiple chained Roboclaws
I have 8 motors with encoders and home switches, and 4 roboclaw 2x15 boards, and I need to control them all from a single source, preferably a RasPi or similar. How do I need to wire these for control (assuming USB/packet serial and the S1 S2 lines)? I've seen Python libraries here and on GitHub. Ar...
- Wed Mar 27, 2019 6:42 am
- Forum: Velocity and Position Control
- Topic: Encoders on GoBilda motors
- Replies: 4
- Views: 6113
Re: Encoders on GoBilda motors
I investigated further. I have several of these motors and tried a different one with the identical wiring setup as the first one, and the second motor's encoder works fine. So I guess the first motor has a bad encoder?
- Tue Mar 26, 2019 11:20 am
- Forum: Velocity and Position Control
- Topic: Encoders on GoBilda motors
- Replies: 4
- Views: 6113
Re: Encoders on GoBilda motors
I’m powering them with 5V from the Roboclaw.
- Tue Mar 26, 2019 6:48 am
- Forum: Velocity and Position Control
- Topic: Encoders on GoBilda motors
- Replies: 4
- Views: 6113
Encoders on GoBilda motors
I have a 5202 Series Yellow Jacket Planetary Gear Motor (5.2:1 Ratio, 1150 RPM, 3.3 - 5V Encoder), powering a ServoCity linear actuator kit. I am trying to get the motor encoder to be recognized by a RoboClaw 2x15A Motor Controller. Do the A and B signal lines from the encoder need pull-up resistors...