Search found 4 matches
- Wed Sep 15, 2021 8:13 am
- Forum: Velocity and Position Control
- Topic: Having trouble getting absolute or quadrature position working
- Replies: 2
- Views: 8576
Re: Having trouble getting absolute or quadrature position working
Thank you for your reply, there is so much to learn when it comes on to working with encoders. I will take this into consideration and using gearbox output ratio to determine the values needed to tune the encoders.
- Thu Aug 26, 2021 10:52 am
- Forum: Velocity and Position Control
- Topic: Having trouble getting absolute or quadrature position working
- Replies: 2
- Views: 8576
Having trouble getting absolute or quadrature position working
I know this question may have asked several times before, but it is hard to use the search feature to narrow search for a specific topic. My issue is trying to do position control with either an absolute encoder (5K pot) or via using a servocity yellow jacket motor with built-in quadrature encoder. ...
- Mon May 04, 2020 11:58 am
- Forum: General Discussion
- Topic: Using Packet Serial in .NET - RoboClaw 2x60a
- Replies: 3
- Views: 4694
Re: Using Packet Serial in .NET - RoboClaw 2x60a
Thanks for this response. As it turns out, based on the documentation and a post I stumbled upon here, the RoboClaw needs to commands a drive and a turn command before it will start moving :oops: . In my previous post, I was sending the mixed ForwardBackward command without any turn command. I refac...
- Sat May 02, 2020 8:17 pm
- Forum: General Discussion
- Topic: Using Packet Serial in .NET - RoboClaw 2x60a
- Replies: 3
- Views: 4694
Using Packet Serial in .NET - RoboClaw 2x60a
Hello, Sorry if this question have been asked and answered before, but I am having a tremendously communicating with RoboClaw 2x60a, purchased through ServoCity, using the packetized serial protocol from a .NET based program. Standard serial seems to work, but I am looking to send more advanced comm...