Search found 2 matches
- Thu May 21, 2020 2:10 pm
- Forum: Velocity and Position Control
- Topic: RoboClaw Solo 60A conneting to a AndyMark PG188 motor
- Replies: 3
- Views: 3564
Re: RoboClaw Solo 60A conneting to a AndyMark PG188 motor
Using Basicmicro Motion Studio
Checked Connectors, appear correct
Does pin 1 and 2 need to be connected to a seperate 5v source?
the Speed is going from positive to negative and the Encoder 0 to -2
Is there any thing that needs to be set on the General Settings page to support the encoders?
Thanks
Checked Connectors, appear correct
Does pin 1 and 2 need to be connected to a seperate 5v source?
the Speed is going from positive to negative and the Encoder 0 to -2
Is there any thing that needs to be set on the General Settings page to support the encoders?
Thanks
- Wed May 20, 2020 10:14 am
- Forum: Velocity and Position Control
- Topic: RoboClaw Solo 60A conneting to a AndyMark PG188 motor
- Replies: 3
- Views: 3564
RoboClaw Solo 60A conneting to a AndyMark PG188 motor
Dear Support.
Looking for any guidance of how to configure the Pulse encoder on the PG188 to work with Motor Driver.
I used the encoder cable, am-2992 (from AndyMark)
I am using Ion Studio to test, and the Speed is going from positive to negative and the pulse 0-1
Thanks Joe
Looking for any guidance of how to configure the Pulse encoder on the PG188 to work with Motor Driver.
I used the encoder cable, am-2992 (from AndyMark)
I am using Ion Studio to test, and the Speed is going from positive to negative and the pulse 0-1
Thanks Joe