BasicMicro

ok, I know what you mean, but I don't understand Why the motors doesn't move at all when I select RC input mode control (in Roboclaw panel) and it Works perfect when I select Analog mode Control. In analog mode Control the motors run perfect forward and reverse when I control them from the joystick ...

I solved parcially the problem with your suggesttion: .."Normal analog mode autocalibrates to the input signal on power up. Set MCU option to disable autocalibration then trim to zero speed using the pixhawk settings…" Now, the ROboclaw Start a full speed but it stop when the pixhawk is re...

Yes, I think so about RC output but when I select RC control it doesn't work at all, the motors don't move…
Only Works fine with Analog mode selected...

I have a problem with the RoboClaw 2x60A Motor Controller. I have wiring it to two brushed motors and a 24 Vdc batery. I have connected to a Pixhawk like analog control mode and I have select Exponential RC/Analog Options. Everything Works fine but when I power off and power on again, the motors run...