Search found 1594 matches

by Basicmicro Support
Wed Apr 01, 2015 9:00 am
Forum: General Discussion
Topic: Getting out of E-Stop / enable pin
Replies: 3
Views: 6387

Re: Getting out of E-Stop / enable pin

Once E-Stop, Over voltage or a driver error state triggers the unit can not be cleared without power cycling it. This is to prevent just resetting constantly and then eventually damaging the unit. All other error states will clear when the problem is corrected. This is in regards to the latest firmw...
by Basicmicro Support
Sun Mar 22, 2015 12:30 pm
Forum: General Discussion
Topic: Roboclaw 2x30 Choppy Response
Replies: 3
Views: 7873

Re: Roboclaw 2x30 Choppy Response

If the QPPS is not set correctly this kind of behavior can happen. I recommend you check your QPPS setting. It should be equal to the encoder speed when the motor is running at 100% power.
by Basicmicro Support
Sun Mar 22, 2015 12:28 pm
Forum: General Discussion
Topic: Firmware Update
Replies: 5
Views: 11262

Re: Firmware Update

Please check the latest version. firmware 4.1.5. Also is this only specific to a particular mode?
by Basicmicro Support
Sun Mar 22, 2015 12:26 pm
Forum: General Discussion
Topic: roboclaw 2*30A not working
Replies: 1
Views: 5588

Re: roboclaw 2*30A not working

Hold the Mode button pressed while powering up the board will put it into bootloader mode(only on boards with USB). On older boards without USB or 2x5A boards that dont have USB if the firmware has somehow been corrupted(more likely the processor was damaged somehow) you can send it in to be checked...