Search found 1594 matches
- Wed Apr 01, 2015 9:00 am
- Forum: General Discussion
- Topic: Getting out of E-Stop / enable pin
- Replies: 3
- Views: 6421
Re: Getting out of E-Stop / enable pin
Once E-Stop, Over voltage or a driver error state triggers the unit can not be cleared without power cycling it. This is to prevent just resetting constantly and then eventually damaging the unit. All other error states will clear when the problem is corrected. This is in regards to the latest firmw...
- Sun Mar 22, 2015 12:30 pm
- Forum: General Discussion
- Topic: Roboclaw 2x30 Choppy Response
- Replies: 2
- Views: 7954
Re: Roboclaw 2x30 Choppy Response
If the QPPS is not set correctly this kind of behavior can happen. I recommend you check your QPPS setting. It should be equal to the encoder speed when the motor is running at 100% power.
- Sun Mar 22, 2015 12:28 pm
- Forum: General Discussion
- Topic: Firmware Update
- Replies: 5
- Views: 11404
Re: Firmware Update
Please check the latest version. firmware 4.1.5. Also is this only specific to a particular mode?
- Sun Mar 22, 2015 12:26 pm
- Forum: General Discussion
- Topic: roboclaw 2*30A not working
- Replies: 0
- Views: 5651
Re: roboclaw 2*30A not working
Hold the Mode button pressed while powering up the board will put it into bootloader mode(only on boards with USB). On older boards without USB or 2x5A boards that dont have USB if the firmware has somehow been corrupted(more likely the processor was damaged somehow) you can send it in to be checked...