Additional response bytes received

General discussion of using Roboclaw motor controllers
woko1754
Posts: 11
Joined: Sun Feb 21, 2021 3:16 am

Re: Additional response bytes received

Post by woko1754 » Thu Sep 30, 2021 8:44 am

The problem starts, if using command "74 - Set S3, S4 and S5 Modes". The command is acknowledged, but after some movement the module starts to send data without request. In my case it is sending the version-string instead of the ACK for an encoder-request.

woko1754
Posts: 11
Joined: Sun Feb 21, 2021 3:16 am

Re: Additional response bytes received

Post by woko1754 » Fri Oct 08, 2021 8:06 am

Is this forum still maintained ? The last answer was nearly 4 weeks ago.

User avatar
Basicmicro Support
Posts: 1566
Joined: Thu Feb 26, 2015 9:45 pm

Re: Additional response bytes received

Post by Basicmicro Support » Fri Nov 19, 2021 12:37 pm

As I said in my last post, I will need to see your code to determine the problem. If you can, post a simplified version that just has enough code to show the problem. Anything that requires special hardware will prevent me from being able to run the code so try to remove anything like that from your example.

Post Reply