Additional response bytes received

General discussion of using Roboclaw motor controllers
woko1754
Posts: 11
Joined: Sun Feb 21, 2021 3:16 am

Re: Additional response bytes received

Post by woko1754 » Thu Sep 30, 2021 8:44 am

The problem starts, if using command "74 - Set S3, S4 and S5 Modes". The command is acknowledged, but after some movement the module starts to send data without request. In my case it is sending the version-string instead of the ACK for an encoder-request.

woko1754
Posts: 11
Joined: Sun Feb 21, 2021 3:16 am

Re: Additional response bytes received

Post by woko1754 » Fri Oct 08, 2021 8:06 am

Is this forum still maintained ? The last answer was nearly 4 weeks ago.

Post Reply