Roboclaw 2x15a ReadSpeed failures

General discussion of using Roboclaw motor controllers
Post Reply
User avatar
Basicmicro Support
Posts: 1594
Joined: Thu Feb 26, 2015 9:45 pm
Re: Roboclaw 2x15a ReadSpeed failures

Post by Basicmicro Support »

I believe I already answered you in an email but this is for everyone.

Manually put your Roboclaw into bootloader mode. Power down. Hold the Mode button pressed, Power back up. Let go of the Mode button. The 3 LEDs should start to cycle. Motion Studio should now recognize the Roboclaw and let you update the firmware.

Post Reply