Saving different profiles/settings

General discussion of using Roboclaw motor controllers
Post Reply
Joe
Posts: 29
Joined: Fri Dec 23, 2016 1:00 am

Saving different profiles/settings

Post by Joe » Sat Jan 07, 2017 10:50 am

How can I save different Roboclaw configuration profiles for testing in Ion Motion Software?

User avatar
Basicmicro Support
Posts: 1338
Joined: Thu Feb 26, 2015 9:45 pm

Re: Saving different profiles/settings

Post by Basicmicro Support » Mon Jan 09, 2017 9:28 am

Currently you can not. We are planning on adding the ability but I'm not sure it will be in the next release.

Joe
Posts: 29
Joined: Fri Dec 23, 2016 1:00 am

Re: Saving different profiles/settings

Post by Joe » Sun Jul 01, 2018 12:01 pm

Hi, I've been away for a while so I missed some versions of IonStudio. Any news on that?

User avatar
Basicmicro Support
Posts: 1338
Joined: Thu Feb 26, 2015 9:45 pm

Re: Saving different profiles/settings

Post by Basicmicro Support » Sun Jul 01, 2018 12:40 pm

The current release doesnt have it yet but the next release will allow you to save/load settings from a file. We added it just this week(after the new release unfortunately).

Joe
Posts: 29
Joined: Fri Dec 23, 2016 1:00 am

Re: Saving different profiles/settings

Post by Joe » Sun Oct 07, 2018 12:49 am

Is it possible now? I can´t find any information in the manual.

User avatar
Basicmicro Support
Posts: 1338
Joined: Thu Feb 26, 2015 9:45 pm

Re: Saving different profiles/settings

Post by Basicmicro Support » Mon Oct 08, 2018 10:26 am

Yes. It is now possible to save/load settings to/from a file in Motion Studio(the new, renamed release).

Post Reply