[SOLVED] IonMotion Interface Hangs on Connect
Posted: Tue Oct 27, 2015 7:30 pm
Hi there,
I am trying to connect a Roboclaw 2x15A to my computer via USB. The computer is running Windows 10. I installed the drivers and the controller is detected correctly when connected.
After installing and starting the IonMotion software, I click on Device->Connect. The interface hangs. No response to any mouse clicks. The STAT1 LED can be seen blinking very quickly.
I tried also on a Windows 7 laptop with the same result.
If I unplug the USB cable after a while I get the error Get Version: A device attached to the system is not functioning.
Any help?
Cheers,
Ibrahim
Edit: Just to add, I've tried different USB ports and different cables, uninstalling and reinstalling drivers and IonMotion, and restarting the computer.
I am trying to connect a Roboclaw 2x15A to my computer via USB. The computer is running Windows 10. I installed the drivers and the controller is detected correctly when connected.
After installing and starting the IonMotion software, I click on Device->Connect. The interface hangs. No response to any mouse clicks. The STAT1 LED can be seen blinking very quickly.
I tried also on a Windows 7 laptop with the same result.
If I unplug the USB cable after a while I get the error Get Version: A device attached to the system is not functioning.
Any help?
Cheers,
Ibrahim
Edit: Just to add, I've tried different USB ports and different cables, uninstalling and reinstalling drivers and IonMotion, and restarting the computer.