roboclaw 2x30 A only 1 motor spinning

General discussion of using Roboclaw motor controllers
Post Reply
User avatar
Basicmicro Support
Posts: 1594
Joined: Thu Feb 26, 2015 9:45 pm
Re: roboclaw 2x30 A only 1 motor spinning

Post by Basicmicro Support »

It sounds like something has happened to the second motor channel. I cant say for sure but if you send the board in we will diagnose the problem and repair the channel if it is a hardware problem.

1. Check both motors on the working channel first. A motor could be damaged.
2. Change the mode back to Packet Serial mode and check each motor channel indvidually with a tested/working motor. Do not check syncronize.

Tell me the results. If they are still what you describe please send the board in with your return address and constact information inside the package.

Post Reply