EPROM broken

General discussion of using Roboclaw motor controllers
Post Reply
PdoubleU
Posts: 12
Joined: Mon Aug 20, 2018 7:05 am
EPROM broken

Post by PdoubleU »

Hi,
I am trying to store and restore all the settings (duty acceleration, PID settings etc.) to the eprom using advanced packet serial.
Like the manual said I am using the command 94 and 95. But different to the manual the roboClaw is not replying by sending 0xFF. Instead it is sending nothing. Am I doning something wrong, or might the EPROM be broken.
User avatar
Basicmicro Support
Posts: 1594
Joined: Thu Feb 26, 2015 9:45 pm
Re: EPROM broken

Post by Basicmicro Support »

Yes. The WriteNVM command has been changed to prevent acidentally running it. If you need to programatically save the NVM settings instead of using IonStudio please contact support@basicmicro.com directly.

Post Reply