Roboclaw 2x120 RC Connection

General discussion of using Roboclaw motor controllers
Post Reply
jobin05@gmail.com
Posts: 2
Joined: Sun Mar 17, 2019 12:41 am
Roboclaw 2x120 RC Connection

Post by jobin05@gmail.com »

I am using Roboclaw 2x120 and I want to know how to connect to a RC receiver . As per the user manual diagram channel 1's 3 wire connect to S1 and channel 2's 3 wire to s2. But as per Roboclaw 2x120 data sheet CTRL only as one wire for s1 and one for s2. My RC receiver has 3 wire each for channel.
User avatar
Basicmicro Support
Posts: 1594
Joined: Thu Feb 26, 2015 9:45 pm
Re: Roboclaw 2x120 RC Connection

Post by Basicmicro Support »

S1 is pin 8 and S2 is pin 6 of the CTRL connector. Connect those to the signal pins of your receiver. Connect pin 5 of the CTRL connector to a GND pin on your Receiver. If you want to power your receiver from Roboclaw 5v connect pin 3 of the CTRL connector to the PWR pin of the Receiver.

It is not entirely clear if this was what you were asking for. If not, please provide a clearer question.
jobin05@gmail.com
Posts: 2
Joined: Sun Mar 17, 2019 12:41 am
Re: Roboclaw 2x120 RC Connection

Post by jobin05@gmail.com »

Yes, I am looking for the same. Thank you for the reply.

Post Reply