RoboClaws x30A and pixhawk4

General discussion of using Roboclaw motor controllers
Post Reply
User avatar
Basicmicro Support
Posts: 1594
Joined: Thu Feb 26, 2015 9:45 pm
Re: RoboClaws x30A and pixhawk4

Post by Basicmicro Support »

I looked at the very short datasheet for the Pixhawk 4. It has serial ports so I assume you can program it to work with Roboclaws packet serial but I doubt it is supported by default(eg you would have to write code to handle it).

Alternatively you can use the Roboclaw RC input mode instead.

Post Reply