Red LED blinks 6X?
Posted: Mon Aug 31, 2020 9:57 pm
Nowhere in the manual or this forum I can find explanation for Red LED blinking 6X. The manual stops at 5X. I'm running Roboclaw 2x15A with 4.1.34 firmware
I got to this point while trying to do manual position tuning (of course after a failed attempt of Auto tuning). Encoder and motor direction seem to be in sync when testing in PWM mode. In Positon mode, moving the slider up/down with P=5 or P=2000 (I and D were 0), I immediately get SE1, PE1 flags and the 6X blinking. When a Stop All button is clicked, the motor will move at maximum speed. I'm not sure if it's trying to reach a certain position since my robot hits the hard limit and stall.
Thank you in advance for any help.
R.
I got to this point while trying to do manual position tuning (of course after a failed attempt of Auto tuning). Encoder and motor direction seem to be in sync when testing in PWM mode. In Positon mode, moving the slider up/down with P=5 or P=2000 (I and D were 0), I immediately get SE1, PE1 flags and the 6X blinking. When a Stop All button is clicked, the motor will move at maximum speed. I'm not sure if it's trying to reach a certain position since my robot hits the hard limit and stall.
Thank you in advance for any help.
R.