The latest update does not work 4.1.26
Posted: Thu Aug 09, 2018 2:27 pm
I had to update from 4.1.24 to 4.1.26 on my roboclaws and it all seemed fine.
Than I re-entered all the settings but the controller wont move.
I got the M1OC and M2OC ligts red, but there is no current going to the motors. The sliders wont move any thing. I got the M1 Max current set at 4A, same for the M2.
The com port is fine, I get readings on the encoders.
Please help, this holds back my entire machine.
Than I re-entered all the settings but the controller wont move.
I got the M1OC and M2OC ligts red, but there is no current going to the motors. The sliders wont move any thing. I got the M1 Max current set at 4A, same for the M2.
The com port is fine, I get readings on the encoders.
Please help, this holds back my entire machine.