Reset encoder through Basic Micro

Questions about using encoders with the Roboclaw product line
Post Reply
User avatar
Basicmicro Support
Posts: 1594
Joined: Thu Feb 26, 2015 9:45 pm
Re: Reset encoder through Basic Micro

Post by Basicmicro Support »

You can not zero an absolute encoder. Because they are absolute encoders. Every position has a unique value.

I believe I talked with you on the phone yesterday. You remembered then you originally had a resistor as we defined in the user manual in series with the 5v input to the pot. Once you put that back in, you should have full range of travel again.

Post Reply