Create a control signal from Labview
Posted: Sun Sep 29, 2019 2:02 pm
Hello,
I have a roboclaw 2x7A, and I am using Labview to control my motors. By now I am using the drivers and I can move the motors.
But I want to create my own control signal, using Labview. I dont want to use the PID control module of the roboclaw, I need to created my own module.
Can this be done??
Thank you in advance
I have a roboclaw 2x7A, and I am using Labview to control my motors. By now I am using the drivers and I can move the motors.
But I want to create my own control signal, using Labview. I dont want to use the PID control module of the roboclaw, I need to created my own module.
Can this be done??
Thank you in advance