How to configure MCP 266 for single direction motor?

General discussion of the MCP motion controller product line
Post Reply
User avatar
RoboGangMower
Posts: 13
Joined: Wed May 23, 2018 1:04 pm

How to configure MCP 266 for single direction motor?

Post by RoboGangMower » Mon Sep 28, 2020 11:44 am

I have some motors that I am trying to run with a remote control (RC transmitter flySky GT5)

How do I make it so the motors only go one direction? I never want them to reverse and the control I am using on the transmitter is a single POT. so pot Min is stop. max is full throttle, mid is just mid.

thanks

User avatar
Basicmicro Support
Posts: 1555
Joined: Thu Feb 26, 2015 9:45 pm

Re: How to configure MCP 266 for single direction motor?

Post by Basicmicro Support » Tue Sep 29, 2020 7:55 am

On the input signal that is controlling the motor set center = min I think will do it.

Post Reply