Page 1 of 1

How to configure MCP 266 for single direction motor?

Posted: Mon Sep 28, 2020 11:44 am
by RoboGangMower
I have some motors that I am trying to run with a remote control (RC transmitter flySky GT5)

How do I make it so the motors only go one direction? I never want them to reverse and the control I am using on the transmitter is a single POT. so pot Min is stop. max is full throttle, mid is just mid.

thanks

Re: How to configure MCP 266 for single direction motor?

Posted: Tue Sep 29, 2020 7:55 am
by Basicmicro Support
On the input signal that is controlling the motor set center = min I think will do it.