TVS Diode Selection?
TVS Diode Selection?
Hello again,
I am having some difficulty figuring out an appropriate TVS Diode that will be appropriate for my intentions. I did a google search and found some notes by MicroSemi (PDF) on this process. To be honest, I have no idea how to perform all these calculations. I just want to get my project going safely.
My system is 24V and is using the MCP263 motor controller with 1000 Watt max peak current motors that nominally operate at 250 Watts 22V. I am trying to build the protection circuit shown in the Data Sheet on page 8.
Here is a list of components I have to complete the circuit
I am having some difficulty figuring out an appropriate TVS Diode that will be appropriate for my intentions. I did a google search and found some notes by MicroSemi (PDF) on this process. To be honest, I have no idea how to perform all these calculations. I just want to get my project going safely.
My system is 24V and is using the MCP263 motor controller with 1000 Watt max peak current motors that nominally operate at 250 Watts 22V. I am trying to build the protection circuit shown in the Data Sheet on page 8.
Here is a list of components I have to complete the circuit
- Switch S1 = Battery cutoff Switch or High Current Continuous Relay - https://www.amazon.com/gp/product/B007O0BBFM or https://www.amazon.com/gp/product/B001FQMZO2
- R1 = 50 Watt 5 Ohm 5% Power Resister - https://www.amazon.com/gp/product/B008MLJM58
- D1 = Unknown TVS Diode
- F1 = Unknown Fuse (roughly 40A)
- Basicmicro Support
- Posts: 1594
- Joined: Thu Feb 26, 2015 9:45 pm
Re: TVS Diode Selection?
The MCP263 already has TVS diode built in so you dont need to add anymore.
For those that want to know though, the TVS should be selected to clamp at the highest voltage the system can survive. TVS diodes will only protect against spikes, not continuous over voltage though the larger the wattage rating of the TVS the longer they will survive an extended overvoltage.
In your case the 260s already have them installed. You just need to get a properly sized fuse. You need to look at the fuse timing table that shows how quickly it will open at a given current. You want it to open quickly in a dead short situation(.1 to 1 seconds at slightly less than the batteries maximum current capability). But you dont want it to open under normal operations.
For those that want to know though, the TVS should be selected to clamp at the highest voltage the system can survive. TVS diodes will only protect against spikes, not continuous over voltage though the larger the wattage rating of the TVS the longer they will survive an extended overvoltage.
In your case the 260s already have them installed. You just need to get a properly sized fuse. You need to look at the fuse timing table that shows how quickly it will open at a given current. You want it to open quickly in a dead short situation(.1 to 1 seconds at slightly less than the batteries maximum current capability). But you dont want it to open under normal operations.
Re: TVS Diode Selection?
Thank you for clarifying. The data sheet doesn't state that unless I missed it.IMC Support wrote:The MCP263 already has TVS diode built in so you dont need to add anymore.
- Basicmicro Support
- Posts: 1594
- Joined: Thu Feb 26, 2015 9:45 pm
Re: TVS Diode Selection?
No, I dont beleive it does. All our models larger than or equal to the Roboclaw 2x60 have TVS diodes. All small models(MCP230,ROboclaw 2x45 and under) do not.