Motor Controller doesn't output 100% duty

Using encoders with the MCP product line
Post Reply
Robert_e
Posts: 1
Joined: Sat Apr 10, 2021 4:38 pm
Motor Controller doesn't output 100% duty

Post by Robert_e »

I'm using the MCP266. When I set the maximum output, I am only reading a 98% duty cycle. Is there a way to get the controller to output a 100% duty cycle?
User avatar
Basicmicro Support
Posts: 1594
Joined: Thu Feb 26, 2015 9:45 pm
Re: Motor Controller doesn't output 100% duty

Post by Basicmicro Support »

Most mosfet drivers use a boost capacitor to generate the high side gate voltage. This requires recharging the cap which requires turning off the high side for a short period of time. This limits the on-time to around 98%.

Post Reply