Page 1 of 1

Manual homing

Posted: Thu Sep 23, 2021 6:30 am
by woko1754
Is there a command to start the homing manually ?

Re: Manual homing

Posted: Fri Nov 19, 2021 12:32 pm
by Basicmicro Support
"Manual" homing just means you give it a command to move the motor backwards into the home sensor. :) You can use any command(Duty, velocity or position) depending on your setup.

Re: Manual homing

Posted: Tue Feb 15, 2022 2:35 am
by woko1754
I got it working with S4-mode set to 'Motor Home(User)/Limit(Fwd)'. When the home-position is reached, the Motors stops and I get the S4-signal, but also the ERR-LED gets on an the module doesn't respond to further commands. How can I resolve this situation ?

With Motion-Studio I get the same problem, but when moving the PWM-control the LED gets off and the Motor is moving.

Update: With command 32 (duty) sent after homing, the LED gets off an the motor is moving. Command 119 (position) does not work this way.