Using encoders with the MCP product line
- Posts: 7
- Joined: Wed Jun 20, 2018 3:09 am
I would to know if it is possible to use position control with quadrature encoders or if position control is limited to absolute encoder ?
- Posts: 1130
- Joined: Thu Feb 26, 2015 9:45 pm
Yes, you can use position control with quadrature encoders. A proper homing sequence is required if you want repeatable positions after a power cycle.
Return to “Velocity and Position Control”
Who is online
Users browsing this forum: No registered users and 1 guest