Page 1 of 1

Triggering DOUT

Posted: Tue Apr 04, 2017 2:19 pm
by biznasty123
Anyone have luck activating the digital output pins? Is there a supply voltage requirement?

I am trying to use the digital output to operate external pneumatic brakes using a command in a MCL script such as DOUT(0) = 1.

I don't want a certain operational condition to trigger them... I'd like them to pull high via my command with a switch/sensor input.

Any insight is appreciated. The digital out is connected to a voltage regulator powering a relay which in turn is switching a solenoid valve.

Re: Triggering DOUT

Posted: Wed Apr 05, 2017 10:17 am
by Basicmicro Support
Please email They will be able to give you a tested example that shows how to do this.