Logic battery says .7v, error light on, still runs fine

General discussion of the MCP motion controller product line
Post Reply
User avatar
RoboGangMower
Posts: 14
Joined: Wed May 23, 2018 1:04 pm
Logic battery says .7v, error light on, still runs fine

Post by RoboGangMower »

Since the new firmware update, my mcp266 has error light always on and the logic battery voltage states .7v. I assume this is not correct as it still operates fine.

Please advise
User avatar
Basicmicro Support
Posts: 1594
Joined: Thu Feb 26, 2015 9:45 pm
Re: Logic battery says .7v, error light on, still runs fine

Post by Basicmicro Support »

Anything under 3v is ignored as it usually indicates a floating Logic Battery input(eg nothing attach). If you aren't otherwise having problems you can ignore it. If you are you can ground the Logic battery input(eg connect one pin to the other on the Logic battery plug. That should hold the logic battery analog reading at 0v.

Post Reply