STOP all by sotware
-
- Posts: 37
- Joined: Wed Jul 31, 2019 7:24 am
STOP all by sotware
Is it possible to configure an external button that stops the operations like STOP ALL in the tool software?
- Basicmicro Support
- Posts: 1594
- Joined: Thu Feb 26, 2015 9:45 pm
Re: STOP all by sotware
Yes, that would be the E-Stop input. Note that when using Latching E-Stop you have to power cycle the board to clear it. For this use you should not use the latching option.
-
- Posts: 37
- Joined: Wed Jul 31, 2019 7:24 am
Re: STOP all by sotware
Sorry but I don't get how to configure it.
I have selected "Hardware" in "E-Stop Reset Method".
In the mode of a Digital input I can select only "Analog" or "Pulse". Where should I select "Latching"?
I have selected "Hardware" in "E-Stop Reset Method".
In the mode of a Digital input I can select only "Analog" or "Pulse". Where should I select "Latching"?
- Basicmicro Support
- Posts: 1594
- Joined: Thu Feb 26, 2015 9:45 pm
Re: STOP all by sotware
Ah, you appear to be using a MCP. On MCP you need to setup the input pin(Analog or Digital mode depending on the specific pin capabilities). Then you need to set the Min or Max Action. The action options can be set to stop both motor. The min and max range settings need to be set high(for min) and lower(for max range) than the inputs actual low and high value. That way the min and/or max action will trigger when you set/clear the input.
Re: STOP all by sotware
Hello,
I'm new and I need some help.
In serial mode, what the command or suit of commands I must send for obtain the same result as STOP ALL on the basicmicromotiontudio...
I use this command : SpeedAccelDistanceM1M2 and I would like STOP ALL the motors. (I use an arduino)
I'm 100% software.
Thanks for the answer
I'm new and I need some help.
In serial mode, what the command or suit of commands I must send for obtain the same result as STOP ALL on the basicmicromotiontudio...
I use this command : SpeedAccelDistanceM1M2 and I would like STOP ALL the motors. (I use an arduino)
I'm 100% software.
Thanks for the answer
- Basicmicro Support
- Posts: 1594
- Joined: Thu Feb 26, 2015 9:45 pm
Re: STOP all by sotware
The Stop All button in Motion studio uses the M1M2Duty command and sets the duty of each motor to 0.
Re: STOP all by sotware
Perfect !Basicmicro Support wrote: ↑Wed Oct 02, 2019 11:30 am The Stop All button in Motion studio uses the M1M2Duty command and sets the duty of each motor to 0.
Thank you very much !