How to configure MCP 266 for single direction motor?
- RoboGangMower
- Posts: 14
- Joined: Wed May 23, 2018 1:04 pm
How to configure MCP 266 for single direction motor?
I have some motors that I am trying to run with a remote control (RC transmitter flySky GT5)
How do I make it so the motors only go one direction? I never want them to reverse and the control I am using on the transmitter is a single POT. so pot Min is stop. max is full throttle, mid is just mid.
thanks
How do I make it so the motors only go one direction? I never want them to reverse and the control I am using on the transmitter is a single POT. so pot Min is stop. max is full throttle, mid is just mid.
thanks
- Basicmicro Support
- Posts: 1594
- Joined: Thu Feb 26, 2015 9:45 pm
Re: How to configure MCP 266 for single direction motor?
On the input signal that is controlling the motor set center = min I think will do it.