RoboClaw 2x15A error
- Basicmicro Support
- Posts: 1594
- Joined: Thu Feb 26, 2015 9:45 pm
Re: RoboClaw 2x15A error
You need to see what the error is. Based on the description the LED is indicating a warning, not an error(errors would stop the motor controller). My guess is a over current warning which is probably a false overcurrent. you can check using Motion Studio. Assuming that is the case go into General Settings and change the default current blanking window from 5.4% to 7 or 8% and see if the problem goes away. Remember to write settings from the Device menu after making the changes.