mode percent
-
fausto.tromba
- Posts: 37
- Joined: Wed Jul 31, 2019 7:24 am
mode percent
In General Settings--> Coomand Settings, it is possible to select with the MCP236 the Mode Position, Mode Instant Speed, Mode Average speed and Mode Percent.
What is it?
I would like to control the motor in current mode with a external analog signal (ACS712).
What is it?
I would like to control the motor in current mode with a external analog signal (ACS712).
-
Basicmicro Support
- Posts: 1594
- Joined: Thu Feb 26, 2015 9:45 pm
Re: mode percent
That lats you set what is used to calculate the command value. Position is the most common, but under special cases you may want the inst/average speed to drive the motor(like when using a job dial) or you way want the percentage of the throw of the input to control the command output.