Cannot get Encoder value using ReadEnc command
- Basicmicro Support
- Posts: 1594
- Joined: Thu Feb 26, 2015 9:45 pm
Re: Cannot get Encoder value using ReadEnc command
1. You need your encoders to work correctly before anything else.
2. No, this is not normal. You should be able to manually move the motors extremely slowly and STILL get clean encoder readings. My guess is you need to add 5v pullups to the encoder lines on your motors.
2. No, this is not normal. You should be able to manually move the motors extremely slowly and STILL get clean encoder readings. My guess is you need to add 5v pullups to the encoder lines on your motors.