Starting thread for user manual updates / corrections
Posted: Mon Apr 18, 2022 8:45 am
Hi--
Basic Micro has some truly innovative products at solid price point. We linux folks typically have to tweak/write code to get our desired functionality, which causes us to read the documentation. Usually cover to cover.
I found a couple corrections and thought by starting a thread, we could have the community crowd source the updates and the folks at Basic Micro could do a single update.
So I'll start, in version 5.7 of the user manual (latest and greatest):
Page 76:
100 - Set CTRL Modes
Set CTRL modes of CTRL1 and CTRL2 output pins(available on select models).
Send: [Address, 20, CRC(2 bytes)]
Receive: [0xFF]
Command should be 100, an not 20. which conflicts with the Reset Qual Encoders command.
Any others?
Thanks,
Ron
RC 2x7A
Basic Micro has some truly innovative products at solid price point. We linux folks typically have to tweak/write code to get our desired functionality, which causes us to read the documentation. Usually cover to cover.
I found a couple corrections and thought by starting a thread, we could have the community crowd source the updates and the folks at Basic Micro could do a single update.
So I'll start, in version 5.7 of the user manual (latest and greatest):
Page 76:
100 - Set CTRL Modes
Set CTRL modes of CTRL1 and CTRL2 output pins(available on select models).
Send: [Address, 20, CRC(2 bytes)]
Receive: [0xFF]
Command should be 100, an not 20. which conflicts with the Reset Qual Encoders command.
Any others?
Thanks,
Ron
RC 2x7A