Configuration writing problem?
Posted: Thu Nov 23, 2023 3:49 am
After installing new Version of Motion Studio (Win10 and Win11) and upgrading FW I configured the
controller as before. When I try to write the configuration I get a
"Not Responding" message (little window) in Motion Studio and the Controller does not work
as expected. Sometimes the motor is jerking when I write configuration sometimes not.
In my case I'm using a home and a limit switch and I was used that the
motor was homing in the past. Now the motor doesn't move anymore to home position when I
power on the Roboclaw.
S4 mode is set to Motor Home(Auto)/Limit(Fwd)
Any suggestions?
controller as before. When I try to write the configuration I get a
"Not Responding" message (little window) in Motion Studio and the Controller does not work
as expected. Sometimes the motor is jerking when I write configuration sometimes not.
In my case I'm using a home and a limit switch and I was used that the
motor was homing in the past. Now the motor doesn't move anymore to home position when I
power on the Roboclaw.
S4 mode is set to Motor Home(Auto)/Limit(Fwd)
Any suggestions?