See the RoboClaw 2X30A wired up to Arduino UNO and 2 Motors
Posted: Tue Jun 21, 2016 4:16 pm
Hi,
So I have a web site that shows the project I'm working on. Basically a robot called the Agent 390. It has 2 X 12 volt (max 20A) motors, these are connected to the RoboClaw 2X30A, and this is all controlled via an Arduiono UNO. Next is to drive the Arduino board with a Raspberry Pi 3 using C++, it will use some Artificially Intelligent (adaptive) object avoidance, and navigation system algorithms to move around my house. See it all here :
Entry on Motor shields and the RoboClaw
http://www.roboticsfordreamers.com/#!us ... elds/omamr
Blog Entry on connecting it up to the robot
http://www.roboticsfordreamers.com/#!Da ... 67914fa778
Thanks.
Marcus
So I have a web site that shows the project I'm working on. Basically a robot called the Agent 390. It has 2 X 12 volt (max 20A) motors, these are connected to the RoboClaw 2X30A, and this is all controlled via an Arduiono UNO. Next is to drive the Arduino board with a Raspberry Pi 3 using C++, it will use some Artificially Intelligent (adaptive) object avoidance, and navigation system algorithms to move around my house. See it all here :
Entry on Motor shields and the RoboClaw
http://www.roboticsfordreamers.com/#!us ... elds/omamr
Blog Entry on connecting it up to the robot
http://www.roboticsfordreamers.com/#!Da ... 67914fa778
Thanks.
Marcus