Firmware problems with RoboClaw 2x15A V4

General discussion of using Roboclaw motor controllers
Post Reply
User avatar
Basicmicro Support
Posts: 1594
Joined: Thu Feb 26, 2015 9:45 pm
Re: Firmware problems with RoboClaw 2x15A V4

Post by Basicmicro Support »

The configuration was reset when the firmware was updated. The mode by default is set to Packet Serial mode. You just need to change the mode to RC mode(and possibly enable mixing if you are using a differentially steered robot).
Top
Post Reply

Return to “General Discussion”