Help with saving settings to Robo claw solo 60

General discussion of the MCP motion controller product line
Post Reply
Will01
Posts: 2
Joined: Sat Apr 13, 2019 2:00 am

Help with saving settings to Robo claw solo 60

Post by Will01 » Sat Apr 13, 2019 2:10 am

Hi all, I am new to building projects with electrical components, so this might seem a dumb as question! However I can find a way to save the mode setting ( RC ) to Robo using the Basic Micro motion studio, I have checked the box, file save then turn Robo off and back on that's all the info I could find in the manual to do.
But it never saves and therefore is no response when the RC controller is used to move motor 1.

any help would be appreciated :)

User avatar
Basicmicro Support
Posts: 1180
Joined: Thu Feb 26, 2015 9:45 pm

Re: Help with saving settings to Robo claw solo 60

Post by Basicmicro Support » Mon Apr 15, 2019 10:14 am

Under the Device menu click Write Settings. The File menu is for saving your settings to a file on your computer so you can load them again for another controller or as a back up(which is why it is in the File menu). Write Settings in the device menu tells the Roboclaw to write its settings from Ram to non-voltaile memory(which is why its in the device menu).

Post Reply