OC1 after Autotune

Questions about using encoders with the Roboclaw product line
Post Reply
calnrv
Posts: 1
Joined: Tue Sep 17, 2019 2:33 pm

OC1 after Autotune

Post by calnrv » Tue Sep 17, 2019 2:39 pm

I am using a GolBilda motor with a Roboclaw (2x7A) motor controller. I am trying to autotune the motor via the Velocity Settings tab in the Motion Studio software.

In at least two different motors, the autotune gets stuck and I had force close the program, restart the program. After this point: the motor has problems running. It shows the ERR LED blinking and the status of the OC1 in the motion studio is yellow (blinking). After this point, the operation of the motor becomes iffy. The other motor driver is still intact.

Can you please tell me if there is a problem in the motor controller or I am doing anything wrong?

Thanks,
Raghu.

User avatar
Basicmicro Support
Posts: 1258
Joined: Thu Feb 26, 2015 9:45 pm

Re: OC1 after Autotune

Post by Basicmicro Support » Wed Sep 18, 2019 9:46 am

If the motor is acting up but the motor channel drives other motors properly, the problem is most likely in the motor. If something is shorting in the motor that would cause the over current. I would also check wiring to the motor to make sure it isnt something shorting before power get to the motor.

It is very very rare for a motor to fail but it does happen. I killed one accidently by over driving the voltage and current to the motor. It took a while though.

Please provide a link to the motor specs and what voltage you were driving the motor at. The 2x7A can supply up to 15amps per motor channel. That is enough to damage some small motors.

Also make sure you are using the latest Basicmicro Motion Studio software, Not older Ion Motion/Studio software.

Post Reply