Unpopulated boards?

General discussion of using Roboclaw motor controllers
Post Reply
Posts: 1
Joined: Thu Nov 14, 2019 9:14 am

Unpopulated boards?

Post by cbbbui » Thu Nov 14, 2019 9:19 am

Hey there,

having a lot of trouble trying to put together a more permanent circuit because the headers that come with the board. I want to solder wires onto the board, or have some better connection method. I ended up unsoldering the headers, but that was a nightmare that lead to a fried MCU (I think).

So, is there the option to get an unpopulated board? I'm open to other alternatives too.


User avatar
Basicmicro Support
Posts: 1518
Joined: Thu Feb 26, 2015 9:45 pm

Re: Unpopulated boards?

Post by Basicmicro Support » Thu Nov 14, 2019 9:30 am

Unfortunately no there is not. We can not ship both populated and unpopulated versions.

I usually recommend two alternatives. 1: Use a 2xX pin .1" spaced female header. Here is a link to ones available from AdaFruit. The more populated pins the stronger the hold.


Uses these jumper wires:


Alternatively you can go with the 2x45 Screwterminal version of the Roboclaw.

A third option is to plug your wires in and then zip tie them with some relief nearby or to one of the Roboclaw mounting holes.

Post Reply